Chuck shows you how to build a simple Automatic Power Off Control for Your ENDER 3 or Any 3D Printer that doesn't use Octoprint. He uses a stock Ender 3 and adds the basic components that cost less than $30 to create a safe and reliable auto-off system. The Power Relay used in the project is controlled by a low voltage signal and is safer than trying to wire a relay directly in the power supply. All the components, tools and 3D prints used in the project are listed below. Note: As an Amazon Associate, I earn from qualifying purchases.
Auto Power Off: Components and Tools:
Ender 3 Switch:
Power Relay:
Solder Sleeve Kit:
T-Nuts Kit:
Connector Kit:
Crimping Tool:
9 Volt Power Adapter:
Switch + Wiring Harness:
9 Volt Battery Clip:
3D Prints used in the project:
9 Volt Battery Holder:
Switch Mount:
Cura Profiles:
Cura Download:
Financial Support through Patreon:
Creality Ender 3:
From Banggood :
From Gearbest :
From MatterHackers:
Direct from Creality:
Ender 3 Pro:
From Banggood.com:
From MatterHackers:
Direct from Creality:
Ender 3 Upgrade Package (Extruder, Silent Board & Capricorn Tubing):
CHEP Cura Profiles:
CHEP CUBE:
CHEP PAWN:
Phil A Ment:
3D Benchy:
Filament Friday Tool Kit:
USA -
UK -
Filament Friday Filament:
USA -
ENDER 3 Parts/Upgrades
-------------------------------------------
X-Axis Tensioner
Y-Axis Tensioner
CHPOWER Metal Extruder:
USA:
UK:
Banggood:
WINSINN Dual Gear:
USA:
UK:
Banggood:
EZR Extruder:
Creality Silent Stepper Board:
Cap Tubes & Couplings:
CR10/Ender 3 Nozzles:
CR10/Ender3 Silicon Heater Block Cover:
Solder Sleeve Kit:
Ender 3 Fan Set (24v):
CR-10 Fan Set (12v):
T-Nuts Kit:
Screw Kit:
Temperature Meter Used in Videos:
Screwdriver set used in Videos:
CHEP Prusa Profiles:
CR-10 V2
From Creality:
From Banggood:
From Gearbest:
CR-10:
From Creality:
From Banggood :
From GearBest.com :
CR-10S Pro
From Creality:
From Banggood :
From Matterhackers:
From Gearbest:
CR10 Mini
From Banggood :
Creality Ender 5:
Banggood.com:
Gearbest:
Direct from Creality:
Filament Friday Tool Kit:
Filament Friday 3D Printer Starter Kits:
Filament Friday Filament:
***** Support the Channel ******************
EBAY USA:
EBAY UK:
EBAY Canada:
Support the Channel here and shop at MatterHackers.com and you automatically donate to the channel at no cost to you:
Note:
As an Amazon Associate, I earn from qualifying purchases.
****************************************************
Filament Friday Sticker:
Send Self Addressed Stamped Envelope to:
Electronic Products
PO Box 251
Milford, MI 48381
****************************************************
Filament Friday Playlist:
Chuck's Arduino Book:
Intro animation by Pablo Licari based on Filament Friday Logo by Brian Carter.
0 Comments